Hello guys, Welcome to Africa's Largest Video Search Engine, and you are watching Watch as an xterra drive shaft carrier center support bearing goes bad!. and this video is uploaded by Adam Heidingsfelder at 2014-03-15T14:54:00-07:00. We are just promoting this video only for entertainment and educational purpose only. I hop you like our Video Search Engine. [Sx4hTc9jlIc]
| Name | Watch as an xterra drive shaft carrier center support bearing goes bad! |
| Video Uploader | Video From Adam Heidingsfelder |
| Upload Date | This Video Uploaded At 15-03-2014 21:54:00 |
| Video Discription | UPDATE: Got it fixed. $27 part off ebay. Needed 14mm to Remove the housing. 8mm to remove the U joints, which were fine. Removed the drive shaft from the Transmission. 24mm (15/16 I think) to remove the bolt that holds the wrist of the U joint/driveshaft. Put the shaft in a vice and tapped it off then tapped the bearing out. Used a pipe to tap the new bushing/bearing back in and re-bolted it all back together. Not a bad job. Took 2 hours, and I was going slow and being VERY careful since I've never done it before. 2003 nissan xterra 2.4L 2 WD Noise sounded like a bad bearing or bad brakes. also called driveshaft support bearing or bushing. the truck used to only vibrate over 60mph, now it vibrates randomly. there was a squeaking sound like worn brakes for the longest that I couldn't pin down. Here is a linkk to my forum discussion: http://www.clubxterra.org/forums/showthread.php?t=80386 [Sx4hTc9jlIc] |
| Category | Entertainment |
| Tags | Nissan Xterra (Automobile Model) |
