Hello guys, Welcome to Africa's Largest Video Search Engine, and you are watching What is the reason for the burrs on the bottom of the cuting sample?. and this video is uploaded by Oree Laser at 2021-03-12T03:00:53-08:00. We are just promoting this video only for entertainment and educational purpose only. I hop you like our Video Search Engine. [F8AS8zMy4Vw]
| Name | What is the reason for the burrs on the bottom of the cuting sample? |
| Video Uploader | Video From Oree Laser |
| Upload Date | This Video Uploaded At 12-03-2021 11:00:53 |
| Video Discription | 【Possible Causes】: 1. The nozzle diameter is too small to meet the processing requirements; 2. The negative defocus does not match, the negative defocus should be increased, and the appropriate position should be adjusted; 3. The air pressure is too small, resulting in burrs on the bottom and unable to fully cut. 【Solution】: 1. Use large-caliber nozzles to increase air flow; 2. Increase the negative defocus to make the cutting section reach the bottom position; 3. Increasing the air pressure can reduce the bottom burr. [F8AS8zMy4Vw] |
| Category | Science & Technology |
| Tags | Science & Technology Download MP4 | Science & Technology Download MP3 | Science & Technology Download MP4 360p | Science & Technology Download MP4 480p | Science & Technology Download MP4 720p | Science & Technology Download MP4 1080p |
